Customization: | Available |
---|---|
Style: | |
Wave Band: | All Bands |
Suppliers with verified business licenses
Audited by an independent third-party inspection agency
Product Description & Overview
PLUTO+ is a software-defined radio platform which supports 2TX and 2RX, supports Gigabit Ethernet and Micro SD card. It refers to the design for well-known ADI ADALM-PLUTO and improves its shortcomings. PLUTO+ ADC/DAC AD9363 SDR Radio Receiver Transmitter 70MHz-6GHz Software Defined Radio;
Specification:
ADC/DAC: AD9363 (can be cracked to AD9361 or AD9364)
2 transmit channels, 2 receive channels
Radio frequency range: 70MHZ~6GHZ
Reference clock: VCTCXO 40MHZ 0.5ppm
SOC: For Zynq7010 FPGA: 28k
Memory: 512M
Flash memory: 32M
USB: 2.0, support OTG
Ethernet: 1000Mb
Micro SD can be used to boot
DC input: 5V±0.5V-2A microUSB
Interface:
Note that all IO levels are 1.8V.
3.1 When using ADI-PlutoSDR official firmware, please connect URST-MI052.
3.2 When using Pluto+ firmware, you need to support Ethernet, please connect URST-MIO46
3.3 When booting with SD card, please connect SD-H to 1V8
3.4 When using JTAG debugging, please connect JTAG# to ground
3.5 When using external reference clock input, please connect EXCLK to GND
PTT key port:PTT drives the optocoupler through GPIO0 (MI00) and requires an external relay or control circuit.
DFU key:At any time, you can press the DFU button and power up the PLUTO+ again to enter DFU mode, but you will need to connect the URST jumper to MI052.
Refer to CLK input IPEX:
You can input an external high-precision reference clock to the AD9363 through the IPEX interface connection cable.
The main level should not exceed 3.3V. You need to connect the EXCLK jumper to GND to turn off the built-in clock.
Calibrate the frequency of the built-in VCTCXO:
The frequency of the 40M clock can be fine-tuned by adjusting the adjustable resistor next to the VCTCXO, provided you have a reference signal source.
Micro SD:To support SD card booting, you need to connect the SD-H jumper to 1V8.
Notes:
It comes fully assembled and ready to use.
SD card is not included in the package.
Package Included:
1 x SDR Radio PLUTO+
2 x USB Cable