Latest V9 version Malachite Radio Dual Antenna Latest Version 1.10D Malahit-DSP1 Stereo SDR Receiver 50kHz to 250MHz, 400MHz to 2GHz
Features:
1. [Appearance Design] Adopting golden ratio CNC aluminum shell integrated cutting process, fine sand blasting oxidation, exquisite appearance and more texture, aluminum knob with full mechanical feel
2. [Product Details] It supports dual antenna input 50Ohm internal thread internal needle SMA connector, high impedance mode, built-in preamplifier. Optimized the filter and circuit, especially the medium wave part, the performance has been improved, attenuation to 30db, high resistance input, improve short wave sensitivity, there will be better and more stable signal.
3. [Register 1.10D firmware, support 2G] The receiving frequency is 50kHz to 250MHz, 400MHz to 2GHz. If you want to achieve better results when receiving shortwave frequency ranges M, MW, USB, LSB, SSB, it is recommended to use a small loop active outdoor antenna with a frequency of 0.1HZ-30MHZ
4. [Long battery life] The built-in 5000Mah3.7V rechargeable battery, USB type C interface, long battery life, once fully charged, it can be used for 15 hours, and it is very safe to use.
5. It can be connected to a computer via USB, or the receiver can be controlled by a computer. The specific operating instructions are detailed above
6. It has functions such as variable filter width, adaptive noise suppressor, threshold noise suppressor, noise suppressor, AGC, equalizer, etc.
7. [Enhanced screen] It increases the brightness of the screen, which is appropriately higher than the conventional screen brightness on the market, and can be seen more clearly and comfortably in the sun
Product parameter introduction
1) The radio is built on the SDR principle, and the function is determined by the loaded software.
2) Frequency range 10khz-250MHz, 400MHZ-2GHZ
3) Spectrum width 60kHz, 80kHz, 40kHz
4) All types of analog modulation: AM, SSB (LSB USB), CW, NFM, WFM,
5) Powerful functions: variable filter width, adaptive noise suppressor, threshold noise suppressor,
Noise Blanker (AGC_Equalizer.
6) Use the full-featured chip msi001
7) The powerful stm32h743 with a clock frequency of 480 MHz is applied.
8) 3.5-inch IPS display with touch screen.
9) There is a built-in UHF.
10) Controls 2 encoders with buttons and touch screen.
11) Power supply is powered by an external TYPE-C (mobile phone) interface and can be charged by TYPE-C. Internal battery voltage 3.7V capacity 5000mAH.
12) Current consumption when listening to headphones is 300mA.
13) Built-in receiver module To improve HF reception on the antenna, an additional board with a source follower was developed. This board will be built into the standard receiver design.
14) Connected to the computer via USB, CAT, IQ and audio can be transmitted.
15 192kHz span, with scalability.
16) Sensitivity - 0.3μV = 10dB at s/w up to 1GHz.
17) Due to the characteristics of the msi001 chip used, the dynamic blocking range is about 85dB.
18) There is backlight control.
19) SMA female antenna socket;
20) Using temperature compensated crystal oscillator, the frequency stability is up to 1ppm
21) Dynamic up to 82db
22) Pull-rod antenna length: 0.75 meters
23) Dimensions 140X94X30mm (excluding protrusions)
Software features:
Adjustable filter width
Adaptive noise reduction (NR)
Threshold noise reduction
Noise canceller (NB)
Automatic gain control (AGC)
Automatic notch filter (ANF)
Stereo FM supports RDS analog stereo
Equalizer
Packing list:
1 x host
1 x pull-rod antenna
1 x touch pen
1 x bracket
1 x traceless glue
1 x TYPE-C data cable
1 x eva storage bag
1 x lanyard
1 x 3M transparent foot pad
1 x English manual
Packing size: 765g Packing size: 22*12*6cm
Audited Supplier 
){kind=link}